Publish Time: 2021-08-16 Origin: Site
Selective pallet racking is a relatively common type of storage type racking, professional warehouse racking mainly to access pallet goods. Selective pallet racking is generally composed of column pieces (columns), beams, shelves, etc. So how should selective pallet racking be installed? Here is the content list.
Check before installation
Formal installation
Check after installation
Unpack the selective pallet racking and check if the products inside the package are qualified and complete.
Install the column piece of selective pallet racking first. First pad the washers, take out the two uprights, and discharge them in the same order. Then you need to screw on the nut before putting in the screws. Next, remove the cross braces and align one cross brace with the screw hole on the top of the column closest to the bottom foot (with the opening facing up). The other end of the cross brace needs to be padded with washers and installed into the column, and the other end of the diagonal brace is aligned with the relatively high hole of the other column, then take out one diagonal brace, put in the screws and screw on the nut. Install all the diagonal braces in this way. Then put the other end of the cross brace into the same position of the other column, put one diagonal brace into this column after aligning with the hole (opening facing down), put in the screw, and screw it on (no need to tighten). Assemble all the selective pallet racking columns and tighten all the screws. When you reach the top hole, take a cross brace and put it on the column together with the end of the last installed diagonal brace.
After the column piece is finished, a column piece will be manually erected, and then the crossbeam will be hung at the bottom of the column first, and the safety pin will be installed after the crossbeam is hung to prevent the crossbeam from falling off and being dangerous. After both sides of the column piece are hung and connected, the other end of the beam is hung and connected, and finally, each layer of the beam is hung upward according to the demand.
After the upper layer of beams is hung, the bottom layer of beams can be removed. After the installation of the first group of selective pallet racking is completed, you can then proceed to install the back of the racking. After the overall installation of the selective pallet racking is completed, the final adjustment of the specific dimensions will be made. If it is necessary to fix the expansion screws, finally fix them after adjusting the position.
When installing the sub-shelves, first line up the beams and columns of the sub-shelves, then dock them with the columns of the main shelves and adjust the distance.
Once the selective pallet racking has been installed, refer to the acceptance criteria for storage racking and use a rubber hammer to tap the corresponding parts of the columns and beams to adjust them to a more suitable position. The racking is tested by tapping on all parts of the selective pallet racking to see if it is firmly installed. It is also a test of the durability of the racking.
You can find out more about selective pallet racking at https://www.novaracking.com/.
China : Floor 9, Building 1, Zijinxicheng Center, No. 118 Olympic Gym Str., Jianye, Nanjing, Jiangsu, China
US: 3702 W Sample Street,South Bend,Indiana,46619
Our company is a manufacturer of warehouse racks and automation warehouse system. During the past 20+ years, our company has been dedicated to planning, designing, producing and installing rack system and AS/RS system.